Is a 35 min layover in Melbourne long enough?
MEL · Melbourne International · Melbourne, Australia
It Depends
This is the bare domestic-domestic MCT and only works if you're already in the right terminal with light security lines.
Quick Stats
4
20m
15m
Qantas
Minimum Connection Times
35min
tight70min
✗110min
✗100min
✗AD PLACEMENT — CONTEXTUAL
Tips for 35 min Connections
Budget extra time if your connection spans different domestic terminals (T1, T3, T4), as this means exiting security and walking outside before re-screening.
There is no airport train — factor this into arrival timing if you're cutting it close, since ground transport delays can't be shortcut by rail.
International arrivals into MEL must clear passport control, collect checked bags, and pass through customs even if continuing onward — there's no sealed transit corridor.
Qantas domestic-to-international connections within Terminal 1/Terminal 2 are relatively smooth since they're adjacent, but still require a walk and fresh security screening.
If connecting between Jetstar (T4) and Virgin (T3) domestic services, allow generous time as these are on opposite ends of the terminal complex.
Busyness — Connection Risk
12a6a12p6p12a
Low risk
Moderate
High risk
Tight connections are safer outside peak hours. Morning rush (6–9a), midday (11a–2p), and evening (4–8p) are highest risk.
Getting Between Concourses
All terminals sit side-by-side along a single landside terminal building, connected by a covered walkway of roughly 10-15 minutes end-to-end. There is no train or shuttle system — passengers walk the entire distance, and international arrivals must fully clear passport control, collect baggage, and pass through Australian Border Force customs before re-entering any secure zone, domestic or international.
Is 35 minutes enough for a layover at MEL?
This is the bare domestic-domestic MCT and only works if you're already in the right terminal with light security lines.
Other Layover Durations at MEL
AD PLACEMENT — BEFORE FOOTER